Services
Services
The measurement and calibration disciplines available through Cleveland CMM Calibration and Repair.
What Is Offered
Three services cover the dimensional measurement equipment running on Cleveland-area production floors: CMM calibration and repair, CMM programming, and gage calibration.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
- 01
CMM Calibration and Repair
Volumetric accuracy verification and repair for bridge, gantry, cantilever and portable-arm CMMs.
Continue → - 02
CMM Programming
Part-program development and revision for coordinate measuring machines running production inspection.
Continue → - 03
Gage Calibration
Dimensional gauge calibration for ring, plug, block and surface plate standards used on the floor.
Continue →
How the Work Is Carried Out
Work is performed under ISO/IEC 17025:2017. Before work starts, the methods, ranges and measurement points are checked against the request. Results are then issued on a certificate or report recording the method applied, the measurement conditions and the uncertainty attached.
Coverage across Cleveland, OH and the wider Northeast Ohio and the Great Lakes region area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.